User Manual

Detail 4

*Board Arms not

shown for clarity.

NOTE: Remove

old hardware.

6. Using a stable ladder, lift the upper parts of the nets one at a

time and slide the Safety Stop Bolt (#14) through Washer

(#15), grommet on net tab, Spacer (#17) and through the

pole. Then slide the bolt through another Spacer (#17) other

grommet on net tab, Washer (#15) and Nut (#18) as shown

in Detail 5. After the nets are attached, make sure to tighten

Nut (#18) onto Bolt (#14) but be careful not to crush the

grommet on net tab.

Yard Guard

DO NOT DUNK ON THIS UNIT .

DO NOT HANG FROM ANY PART OF THIS

UNIT , INCLUDING THE BACKBOARD, RIM,

SUPPORT BRACES OR NET.

4L-8152-00

WARNING

m no

t s

r cl

(Right)

(Left)

4L-8156-00

WARNI

NOTE: Make sure

Warning Label and

artwork face FRONT.

4. Raise the backboard, by turning the Actuator Crank, until the

lower arms are no longer making contact with the Safety Stops.

Pocket

Figure 3

NOTE: Use hardware from Yard Guard kit to replace the

existing hardware. The #14 bolt in the kit will be longer

that the one on your basketball system.

5. Using a stable ladder carefully remove safety stop bolt

assembly that’s assembled on your pole. See Detail 4.

Detail 5

*Board Arms not

shown for clarity.

Grommet

Pole

Grommet

Pole