User Manual
Figure 1
20” Diameter
16” Diameter
Concrete
Rebar
36”
Court
Court Level
Anchor Plate must be
square to your court so
the backboard will
line up with court.
Court
Top View
(Key #4)
3. Mix and pour concrete into hole. Follow instructions on
concrete bag. Stop about 18" below court level.
4. Insert four reinforcement bars (Key #4) into concrete 8"
apart creating a square in center on hole.
5.
6. Push anchor system into concrete and agitate to work out
voids in concrete. Immediately use a level to level and square
anchor plate to playing surface.
Clean off any concrete that
may be on exposed threads.
Note: The bottom four nuts will be forever embedded
in concrete. The top four nuts remain on bolts and
Let concrete cure for a MINIMUM of 72 hours.
are used for leveling. See your basketball system’s
Note: Failure to dig and fill hole as instructed will result
in increased system vibration.
Note: Using a concrete form for the top 4" of the concrete
is recommended. Cardboard forms can be purchased at
some hardware and home stores or a wooden form can
be constructed out of 2 x 4's.
*Tip: It is always a good idea to purchase two or three
extra bags of concrete, just in case you need them. If
extra bags are not used you can return them to the store.
Place form in desired location and finish pouring concrete
up to court level.
instruction manual.
Figure 3
PLACING THE POST ON THE ANCHOR SYSTEM
REQUIRES AT LEAST FOUR CAPABLE ADULTS.
POLE WILL WANT TO LEAN WHILE ATTEMPTING TO
STAND IT UP ON ANCHOR BOLTS.
Locate hardware needed to mount pole to anchor
bolts. You will need, eight flat washers (#5), four
lock washers (#6), four hex nuts (#1) and four
thread protectors (#7).
Put a flat washer (#5) on each anchor bolt. Lift post
onto anchor system and secure with one flat washer
(#5), one lock washer (#6) and one hex nut (#1)
for each anchor bolt. See Figure 3. Tighten all
four hex nuts tight.
7.
8.
Key# DescriptionPart # Qty.
1
2
3
4
5
6
7
5/8-11 HEX NUT
ANCHOR TEMPLATE
5/8-11 X 14 "J" BOLT
REBAR #3 X 30"
5/8 SAE FLAT WASHER
5/8 SPLIT LOCKWASHER
5/8 THREAD PROTECTOR
12
1
4
4
8
4
4
2B-6097-00
2S-6453-00
2B-6112-00
1S-6167-00
2B-6098-01
2B-6099-00
3M-6469-00
2L-0639-00
2