User Manual

ManualsBrandsSilverback ManualsSilverback Basketball7" Basketball Hoop Anchor Kit Designed for Silverback, Goaliath, and Hoopstar Basketball Hoops

Assemble anchor system as follows: Thread nut (#1)

to bottom of threads on anchor bolt (#3) insert

threads of anchor bolt (#3) through hole on anchor

plate (#2) and secure with nut (#1). Repeat this step

for the remaining anchor bolts. See Figure 2.

NOTE: Each leg of anchor bolts should face the

anchor bolt to the right. See Detail A.

ANCHOR SYSTEM INSTALLATION INSTRUCTIONS

NOTE: For best results with less vibration, anchor system

should be independent of court. If pouring concrete for

both at same time, add an expansion joint in between.

Items needed for Anchor Installation (not included)

9 - 80 lb. bags of concrete (2-3 extra recommended)

1 - post hole digger (optional)

1 - 15/16” open end wrench

1 - 15/16” socket and ratchet (optional)

1 - wheel barrow

1 - garden hose

1 - level

1 - tape measure

1 - concrete form (see note before step 3)

NOTE: When digging hole, if you hit rock

and cannot dig through contact a contractor.

NOTE: Minimum of 18” rear clearance is required behind pole.

MODEL NO.

B1030

SILVERBACK

ANCHOR KIT

Before digging hole for anchor system, check for

buried power, gas, water, and telecommunication

lines! Failure to do so could result in serious or fatal

injury! Contact your local utility company if unsure.

Figure 1

20” Diameter

16” Diameter

Concrete

Rebar

36”

Court

Court Level

Anchor Plate must be

square to your court so

the backboard will

line up with court.

Court

Top View

(Key #4)

Determine the location of the anchor system. The proper

location is as close to the court without making contact,

as shown in Figure 1. This, however, is a general rule.

If you need to locate the anchor system in a location

other than this, check system's owners manual for

overhang of your system.

Figure 2

2L-0639-00

Summary of content (2 pages)

PAGE 1
MODEL NO. B1030 SILVERBACK ANCHOR KIT ANCHOR SYSTEM INSTALLATION INSTRUCTIONS Before digging hole for anchor system, check for buried power, gas, water, and telecommunication lines! Failure to do so could result in serious or fatal injury! Contact your local utility company if unsure. NOTE: For best results with less vibration, anchor system should be independent of court. If pouring concrete for both at same time, add an expansion joint in between.
PAGE 2
Note: Using a concrete form for the top 4" of the concrete is recommended. Cardboard forms can be purchased at some hardware and home stores or a wooden form can be constructed out of 2 x 4's. Figure 1 16” Diameter Court Level Court Top View Note: Failure to dig and fill hole as instructed will result in increased system vibration. *Tip: It is always a good idea to purchase two or three extra bags of concrete, just in case you need them. If extra bags are not used you can return them to the store. 3.