Instructions / Assembly

Page 5Rev. 011520
DiscountRamps.com • 1-888-651-3431
Step 6a. Anti-Tilt - Preferred Option:
Slide the anti-tilt locking device (L) tight up against
the hitch receiver. Insert a hitch pin (N) or pinch bolt
(M) and tighten the bolts using a 17mm wrench.
When tightening the bolts, tighten one side rst until
the rack is level, then tighten the other bolts.
Step 6b. Pinch Bolt - 2nd Option: Insert the carrier into the hitch and install the pinch bolt assembly.
It is required to install either the included anti-tilt locking device or pinch bolt.
Fig. 6a
Installation
Fig. 6b
Fig. 7
Step 7. Securely tighten the hex head pivot bolt on
the hitch tube assembly with a 10mm Allen wrench to
eliminate side-to-side wobble of the hitch carrier. If the
bolt is not properly tightened, it may cause the carrier
to not be level.