Instructions / Assembly

Page 3Rev. 011520
DiscountRamps.com • 1-888-651-3431
Assembly
Step 1. Install the spring pull pin (F) into the front of
the carrier basket (A). Allow the spring pull pin to par-
tially cover the edge of the ramp.
Adjust the spring pull pin with enough room that when
pulled back, the ramp can be lifted out of the carrier
basket. Securely tighten jam nut.
Step 2. Flip the carrier basket assembly upside down and slide the hitch tube assembly into the
center support tube. Align the holes and insert a pin with clip (G). Install two bolts (H) with nuts (I) and
tighten until seated using a 7/8" wrench. Do not over-tighten.
Note: To properly tighten the bolts (H) with jam nuts (I), rst thread the jam nut counterclockwise up
to the head of the bolt. Fully tighten the bolt into the carrier tube. Then tighten the jam nut clockwise
against the carrier tube to secure the bolt.
Fig. 1a
Fig. 1b Fig. 1c
Fig. 2a Fig. 2b