Instructions / Assembly

Page 3Rev. 060518
DiscountRamps.com • 1-888-651-3431
Step 2. Install hold down inner arm (D)
to support tube (B).
Step 3. Install hold down arm (C) to hold down in-
ner arm (D) with hold down arm bolt, washers, and
lock nut. Tighten with 17mm wrench.
*IMPORTANT*
Install washers in
between hold down
inner arm and hold
down arm. This will
allow the arm to stay
in position when
loading and unloading
wheelchair.
(2a)
(D)
(C)
(D)
(B)
(3a)
(3b)
Step 4. Install stabilizer (E) to vehicle
hitch adapter. Tighten side bolts with
10mm wrench.
*Stabilizer is optional depending on
mounting option used. Please refer to
“Determine Best Mounting Height” on
Page 6.
Step 5. Install carrier to hitch adapter and stabi-
lizer with M16x90 bolt (J), M16 washers (G), M16
lock washer (H), and M16 lock nut (I). Secure with
1” wrench.
(4a)
(5a)