User's Manual

NIC 510 and Meter Labeling Product Requirements 23 December 2015 Silver Spring Networks 7
NIC 510 and Meter Labeling Product Requirements 2 FCC and Industry Canada Government Guidelines
This equipment has been tested and found to comply with Part 15 of the FCC Rules. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception (which can be determined by turning the equipment off and on), the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Exigences d'Industrie Canada
La carte d’interface réseau (NIC) Silver Spring Network Relay Point (NRP) DOIT être
installée par un technicien ayant reçu une formation adéquate. Une installation incorrecte
peut annuler l’autorisation de l’utilisateur à se servir de l’équipement.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et.
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
L’antenne de cet émetteur ne doit pas se trouver à proximité de ou fonctionner en association
avec une autre antenne ou un autre émetteur.
Lʹappareil doit être installé de telle sorte que les gens ne viendront pas au sein de 29 cm (11.4
in.) de lʹantenne.
Les changements ou modifications apportés sans l’approbation expresse de l’autorité
responsable de la conformité pourront entraîner l’annulation de l’autorisation d’utilisation
de cet équipement.
FCC and Industry Canada Guidelines for Devices Containing a
Transmitter Module
The following is an extract from FCC PART 15 UNLICENSED MODULAR TRANSMITTER
APPROVAL, DA 00-1407, Released: June 26, 2000, Section 6 describing labeling requirements
for devices containing a modular transmitter.
Section 6. The modular transmitter must be labeled with its own FCC ID number, and, if
the FCC ID is not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: XYZMODEL1” or “Contains FCC ID:
XYZMODEL1.” Any similar wording that expresses the same meaning may be used. The
Grantee may either provide such a label, an example of which must be included in the