User's Manual

I-210+ NIC and Meter Labeling

Product Requirements

Silver Spring Networks - Confidential and Proprietary

NOTE: For FCC compliance, the following text MUST be included in I-210+ and I-210+c

meter manuals and user’s guides.

The antenna of this transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

The device should be installed so that people will not come within 20 cm (8 in.) of the

antenna.

This equipment has been tested and found to comply with Part 15 of the FCC Rules. This

equipment generates, uses and can radiate radio frequency energy, and if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

disconnected.

• Consult the dealer or an experienced Radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by Silver Spring Networks could

void the user’s authority to operate the equipment.

4.1 FCC Guidelines for Devices Containing a Transmitter

Module

The following is an extract from FCC PART 15 UNLICENSED MODULAR TRANSMITTER

APPROVAL, DA 00-1407, Released: June 26, 2000, Section 6 describing labeling

requirements for devices containing a modular transmitter.

Section 6. The modular transmitter must be labeled with its own FCC ID

number, and, if the FCC ID is not visible when the module is installed inside

another device, then the outside of the device into which the module is

installed must also display a label referring to the enclosed module. This

exterior label can use wording such as the following: “Contains Transmitter

Module FCC ID: XYZMODEL1” or “Contains FCC ID: XYZMODEL1.” Any similar

wording that expresses the same meaning may be used. The Grantee may

either provide such a label, an example of which must be included in the

application for equipment authorization, or, must provide adequate

instructions along with the module which explain this requirement.

In the latter case, a copy of these instructions must be included in the application for

equipment authorization."

Figure 9 – Sample FCC ID Label for Devices Containing a NIC

Contains FCC ID: OWS-NIC508, IC: 5975A-NIC508