User Manual

Relay SG 5
Safety Information
 National Electrical Manufacturers Association (NEMA).
 Electronics Industries Association (EIA).
 Insulated Power Cable Engineers Association (IPCEA).
z American National Standards Institute (ANSI). Whenever possible, de-energize all circuits or
equipment before working on them.
z Maintain a minimum clearance of 10 ft. between line potential and all unqualified persons
at all times.
z Keep unauthorized people out of the work area. Be especially cautious of children, who tend
to be drawn to work activity.
z Determining if a circuit is OFF can be difficult in some instances. Check for circuit voltage
with an appropriate voltmeter before working on equipment presumed to have been de-
energized. Tiebreakers, double throw disconnect switches, automatic transfer switches and
emergency generators can supply power through an alternate circuit or from another
source.
z 120V current can be just a lethal as higher voltages because current flow through a body
depends upon the body’s resistance.
z Do not trust insulation and/or weatherproofing on a wire as protection from shock.
z Use electrically insulated tools. Inspect portable electrical equipment or tools for defects
and remove any defective devices from service immediately. All portable electrical
equipment must have Ground Fault Circuit Interrupter (GFCI) protection.
z Select the right tool for the job. Use tools properly. Keep tools in good working order.
z Make sure the work area is free of any flammable material. Flammable vapors can be
ignited by an arc flash.
z Keep the work area clean and dry. Cluttered work areas cause accidents and injuries.
z Provide good lighting in the work area. You cannot work safely if you cannot see what you
are doing.
z Report unsafe conditions or defective equipment to your immediate supervisor.
z Handle material carefully. Lift and carry properly.