User's Manual
Table Of Contents
- Understanding Silver Spring Networks Access Points
- Contents
- 1 About Access Points
- Overview
- Features
- AP Product Description
- Battery Backups
- Read Storage
- Power Requirements
- Rebooting or Recycling APs
- Standards Compliance
- Cellular Modem
- Addressing Schemes
- Specifications
- European Union Compliance
- Maintenance Procedures
- Surge Protection
- Redundant WAN Option
- Mounting Options
- WAN Options
- Throughput Performance
- Responding to a WAN Failure
- Multicast / Unicast Communications
- Networking
- Address Management
- Administration
- Configuration
- 2 FCC and Government Guidelines
- Index
Understanding Silver Spring Networks Access Points 2 FCC and Government Guidelines
Understanding Silver Spring Networks Access Points Rev 3 22 January 2013 Silver Spring Networks 22
• 120V current can be just a lethal as higher voltages because current flow through a body
depends upon the bodyʹs resistance.
• Do not trust insulation and/or weatherproofing on a wire as protection from shock.
• Use electrically insulated tools. Inspect portable electrical equipment or tools for defects
and remove any defective devices from service immediately. All portable electrical
equipment must have Ground Fault Circuit Interrupter (GFCI) protection.
• Select the right tool for the job. Use tools properly. Keep tools in good working order.
• Make sure the work area is free of any flammable material. Flammable vapors can be
ignited by an arc flash.
• Keep the work area clean and dry. Cluttered work areas cause accidents and injuries.
• Provide good lighting in the work area. You cannot work safely if you cannot see what
you are doing.
• Report unsafe conditions or defective equipment to your immediate supervisor.
• Handle material carefully. Lift and carry properly.
Personal Protective Equipment (PPE)
• Always wear Personal Protective Equipment (PPE), in accordance with OSHA and ANSI
standards.
• Wear eye protection and electrically insulated gloves. Test gloves in accordance with
ANSI standards before use. Do not use gloves that do not pass appropriate test
procedures.
• Wear protective clothing such as long sleeve shirts and long pants made of flame resistant
materials.
• Remove all jewelry.
• Do not pass any objects to or from other persons not protected by insulating platforms or
tested, electrically insulated gloves.
Fall Protection
When performing work at any elevation:
• Always use a fall protection system, in accordance with OSHA standards, whenever
performing work at any elevation.
• Never use conductors, guy wires, pins, or cross-arm braces, etc. to support your weight.
• Whenever using aerial lift devices such as hoists, man-lifts, vehicle-mounted work
platforms and overhead lifts, read and follow the manufacturerʹs guidelines for safe and
proper operation.
• Use ladders and scaffolding only in accordance with the manufacturerʹs guidelines
and/or according to OSHA standards.