User's Manual
Table Of Contents
- Understanding Silver Spring Networks Access Points
- Contents
- 1 About Access Points
- Overview
- Features
- AP Product Description
- Battery Backups
- Read Storage
- Power Requirements
- Rebooting or Recycling APs
- Standards Compliance
- Cellular Modem
- Addressing Schemes
- Specifications
- European Union Compliance
- Maintenance Procedures
- Surge Protection
- Redundant WAN Option
- Mounting Options
- WAN Options
- Throughput Performance
- Responding to a WAN Failure
- Multicast / Unicast Communications
- Networking
- Address Management
- Administration
- Configuration
- 2 FCC and Government Guidelines
- Index
Understanding Silver Spring Networks Access Points 1 About Access Points
Understanding Silver Spring Networks Access Points Rev 3 22 January 2013 Silver Spring Networks 11
Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC
This declaration is only valid for configurations (combinations of software, firmware, and
hardware) provided and supported by Silver Spring Networks Inc. The use of software or
firmware not provided and supported by Silver Spring Networks Inc. may result in the
equipment no longer being compliant with the regulatory requirements.
Note: The equipment is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
The following standards were applied:
• EMC: EN 55022 (2010), EN 55024(2010), EN 61000-3-2 (2006)
EN 61000-3-3 (2008), ETSI EN 301 489-3 v1.4.1
• Safety: EN 60950-1:2006, EN 60950-22:2006, BS-EN 62311 (2008)
• Radio: ETSI EN 300 220-1 v2.3.1 (2010-02), ETSI EN 300 220-2 v2.3.1 (2009-12),
The conformity assessment procedure referred to in Article 10 and detailed in Annex IV of
Directive 1999/5/EC has been followed.
Note: This equipment is intended to be used in Luxembourg, United Kingdom, and Portugal in
conjunction with licenses. For more details, contact Silver Spring Networks Compliance.
The product carries the CE Mark:
A copy of the Declaration of Conformity may be obtained with formal request to:
Silver Spring Networks, c/o Hardware Engineering
555 Broadway Street
Redwood City, CA 94063, USA
Declaration of Conformity for RF Exposure
This system has been evaluated for RF exposure for Humans in reference to EN 62311(2008)
Assessment of electronic and electrical equipment related to human exposure restrictions for
electromagnetic fields (0 Hz – 300 GHz). The minimum separation distance from the antenna
to general bystander is 20cm (7.9 inches).
Installation Note
Since APs do not have a power on/off switch for disconnecting AC power before servicing,
AC power is provided through an AC mains disconnect switch or breaker. Therefore, the
electrical installation of this product is under the control of the power utilities or their
authorized subcontractors. Refer to their procedures for further instructions.
Only certain types of batteries can be used for battery replacements. Contact Silver Spring
Networks for information about equivalent battery types that can be used for replacement.