User Manual

MicroAP (NIC 411-3G and 411-3C) and Meter Labeling 7 August 2013 Silver Spring Networks 15
MicroAP (NIC 411-3G and 411-3C) and Meter Labeling 2 FCC and Government Guidelines
• 120Vcurrentcanbejustalethalashighervoltagesbecausecurrentflowthroughabody
dependsuponthebodyʹsresistance.
• Donottrustinsulationand/orweatherproofingonawireasprotectionfromshock.
• Useelectricallyinsulatedtools.Inspectportableelectricalequipmentortoolsfordefects
andremove
anydefectivedevicesfromserviceimmediately.Allportableelectrical
equipmentmusthaveGroundFaultCircuitInterrupter(GFCI)protection.
• Selecttherighttoolforthejob.Usetoolsproperly.Keeptoolsingoodworkingorder.
• Makesuretheworkareaisfreeofanyflammablematerial.Flammablevaporscanbe
ignited
byanarcflash.
• Keeptheworkareacleananddry.Clutteredworkareascauseaccidentsandinjuries.
• Providegoodlightingintheworkarea.Youcannotworksafelyifyoucannotseewhat
youaredoing.
• Reportunsafeconditionsordefectiveequipmenttoyourimmediatesupervisor.
• Handlematerial
carefully.Liftandcarryproperly.
Personal Protective Equipment (PPE)
• AlwayswearPersonalProtectiveEquipment(PPE),inaccordancewithOSHAandANSI
standards.
• Weareyeprotectionandelectricallyinsulatedgloves.Testglovesinaccordancewith
ANSIstandardsbeforeuse.Donotuseglovesthatdonotpassappropriatetest
procedures.
• Wearprotectiveclothingsuchaslongsleeveshirtsand
longpantsmadeofflameresistant
materials.
• Removealljewelry.
• Donotpassanyobjectstoorfromotherpersonsnotprotectedbyinsulatingplatformsor
tested,electricallyinsulatedgloves.
Fall Protection
Whenperformingworkatanyelevation:
• Alwaysuseafallprotectionsystem,inaccordancewithOSHAstandards,whenever
performingworkatanyelevation.
• Neveruseconductors,guywires,pins,orcross‐armbraces,etc.tosupportyourweight.
• Wheneverusingaerialliftdevicessuchashoists,man‐lifts,vehicle‐
mountedwork
platformsandoverheadlifts,readandfollowthemanufacturerʹsguidelinesforsafeand
properoperation.
• Useladdersandscaffoldingonlyinaccordancewiththemanufacturerʹsguidelines
and/oraccordingtoOSHAstandards.
• Onlyuseladdersmadeofnon‐metallic,non‐conductivematerial.Theyshouldbethe
propersizeandtypefortheworkintended.Inspectladdersforwearandbreakage.
Removeanyoil,grease,orotherslipperymaterials.