User's Manual

2
Figure 2. FCC IC Label Location on NIC
This equipment has been tested and found to comply with Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
disconnected.
• Consult the dealer or an experienced Radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by Silver Spring Networks
could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment, and users must follow specific operating instructions for satisfying RF exposure
Compliance. This transmitter must not be co-located or operating in conjunction with any
other transmitter or antenna.
In order to meet FCC’s RF Exposure limits in Section 1.1307 of the Rules, a minimum separation
of 20 cm must be maintained between the antenna of this device during normal operation. The
antenna(s) used for this transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.