User's Manual

9
© 2010 Silver Spring Networks | Company Confidential
Inspect the Pulser Cable
• Inspect the end of the pulser
cable that will connect to the
IMU.
– There should be three wires
exiting the outside insulation.
– The red and black wires are
insulated.
– The 3
rd
wire is bare coming out
of outside insulation, with a
white sleeve on the end.
• If needed, trim the pulser wires
so the conductor is flush with
the insulation and sleeve.
Insert photo
Pulser installation onto the gas meter is not
covered here. Refer to the pulser
manufacturer’s installation instructions.