User's Manual

ManualsBrandsSilver Spring Networks ManualsElectronicsRF Module for Utility Gas Meter

8

9

14

© 2010 Silver Spring Networks | Company Confidential

Program the IMU for Field Use

• Slowly pass the service magnet

once (for 2 to 5 seconds) over the

top of the IMU.

• Watch for the light-emitting diode

(LED) to flash on the lower left

corner of the IMU circuit board

– If you don’t see the LED flash,

make sure the battery cable

connections are made.

– If you still don’t see the LED flash

after checking that all the battery

connections are made and re-

swiping the magnet, return the IMU

to your supervisor. Insert photo

• Configure the IMU with the

programming tool.

(Field

Configuration is a separate document).