User Instructions

Document Type: Test Procedure
Equipment Name: Innovatec C and I Electric
Author: Dithien V. Ho, RF Design Engineer.
Page 22 of 24
4.3.6. [Set Actuator 2 Output]
Type in Electric USN = C&I UUT Serial Number
Set Actuator 1 = OFF
Set Actuator 2 = ON
Press “Transmit”
Make sure to obtain a “Acknowledgement Message “ reply from Incoming Data
Use DVM to verify between Pin 1, J10 (Actuator 1 Output) and Pin 3, J10 (Actuator 1) Common
are “Open”
Use DVM to verify between Pin 2, J10 (Actuator 2 Output) and Pin 4, J10 (Actuator 2) Common
are “Close”
Pass__Fail___
FIGURE 14