User Instructions

Document Type: Test Procedure
Equipment Name: Innovatec C and I Electric
Author: Dithien V. Ho, RF Design Engineer.
Page 21 of 24
4.3. Actuators Test:
4.3.5. [Set Actuator 1 Output]
Type in Electric USN = C&I UUT Serial Number
Set Actuator 1 = ON
Set Actuator 2 = OFF
Press “Transmit”
Make sure to obtain a “Acknowledgement Message “ reply from Incoming Data
Use DVM to verify between Pin 1, J10 (Actuator 1 Output) and Pin 3, J10 (Actuator 1) Common
are “Closed”
Use DVM to verify between Pin 2, J10 (Actuator 2 Output) and Pin 4, J10 (Actuator 2) Common
are “Open”
Pass__Fail___
FIGURE 13