User Instructions

Document Type: Test Procedure
Equipment Name: Innovatec C and I Electric
Author: Dithien V. Ho, RF Design Engineer.
Page 14 of 24
4. Final Assembly Test
The following test is to be performed after the PCA Assembly has been tested and install into appropriate Relay
housing unit.
4.1. General Test
Repeat step 3.3.2. and step 3.3.3., if necessary.
4.1.1. [Set Clock]
Select “Set Clock” message, enter the applicable data then press “Transmit”
Observe “Acknowledged Message “ reply in Incoming Data (See Figure 7)
Pass__Fail__
FIGURE 7