Installation Instruction

No adjustments to the Meter itself are possible. If the unit to be installed does not
communicate with the LAN or does not configure properly, inspect the photocell and AC
wiring and the telephone wiring. If the problem persists, return the Meter to the Meter
Shop for evaluation. Do not attempt to repair the Meter.
FCC WARNING STATEMENTS
NOTE: This equipment has been tested and found to comply with the limits for class B
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. The equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced Radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.