User's Manual

To command an IMU:
1. In the Message Type window select a command from the pull-down menu. See figure 2.
2. Enter the appropriate information in the Outgoing Data window. Notice that the target IMU’s
serial number is displayed at the top of the window. If this serial number is not correct, the
command will go to the wrong IMU. Re-select the desired IMU.
3. In the Transmit window, select
Transmit
.
4. In the Incoming Data window, an acknowledgement that the command was executed will be
displayed. If an acknowledgement is not displayed, the IMU may not have received the
command. Re-send the command by selecting
Transmit
again.
Figure 2. Example of an NCTT Command Screen.