Instruction manual

Quick Start
2.1 Load Batteries
Begin by loading the batteries. Please follow the instructions below.
 Open the bottom cover by pulling down the lock hole.
 Push the cover of the battery compartment and release. It will pop out.
 Install 4 AA batteries. Make sure the polarity matches the sign on the cover.
 Replace the cover.
Alternatively the camera can run on an external 6V DC power source (optional, user provided). When both external
power and batteries are connected, the camera will be powered by the external one.
2.2 Insert SD Card
The camera does not come with internal memory. So it will not work without a SD (Secure Digital) memory card or
SDHC (High Capacity) card. Before inserting the SD card into the card slot, please make sure the write-protect switch
on the side of the SD card is “off” (NOT in the “Lock” position). The supported memory capacity is up to 16GB. If
you use a card capable of above 16GB, make sure you test it before putting the camera in use.
Figure 2.1
CAUTION: ALWAYS SWITCH THE CAMERA TO OFF MODE BEFORE YOU INSTALL OR
REMOVE THE BATTERIES OR THE SD CARD.