Operation Manual

Operation Manual S15-N
Page 4
Please select a suitable port on your PC to connect with the Navtex
receiver cable. Press “OK”.
To save your Navtex messages:
a) Press “EDIT”, then “SELECT ALL” for the following screen:
b) Press “EDIT”, then “COPY (CTRL+C)” and paste the messages to a
designated software (i.e. “Notebook” or “Microsoft Word…).
Note : This terminal is a simulation software with a maximum storage
capacity of 64KB. Please save your incoming Navtex messages
immediately upon receipt to avoid missed messages.
RUNNING THE NAVTEX RECEIVER
Plug the 12-Volt line into the power socket on the receiver Connector and
switch on power .A test message is always sent by the Engine whenever
it is powered up to confirm its correct operation and reception by the PC
RS232 software .If no Welcome and test message is seen on the
PC ,check the settings of the software and that the correct COM port has
been selected.
Once the Welcome and test messages have been sent ,the Navtex
Engine is ready to receive all Navtex signals. In Windows 95 and 98,the
PC can be used for other tasks while the Navtex Engine software runs in
the background.
Select frequency(518/490KHz) by means of switch on the interface
connector.