Owner`s manual

3. Turn the Multi-Navigator off and repeat the procedures in 10.1-5 above until you
reach the lake.
10.1-7 At Ice Lake
You have arrived at Ice Lake. Easy, wasn’t it? Before you start fishing it is a good idea to
cancel the setting for navigating to the lake since you have already found the lake.
1. Press SET in either COMPASS or GPS functions to access SETTINGS.
2. Scroll until you reach CANCEL GOTO and Press YES. This will
3. Switch the Multi-Navigator off and start fishing!
10.1-8 Finding Your Way Back
When you have caught your limit and you want to start back for the
vehicle turn the Multi-Navigator on and wait for it to acquire your
position.
1. Press COMPASS and you will see BACK *HOME*
with the direction and distance. (Fig. 32)
2. Turn your body until you face the direction of your
vehicle, and start your trip back. Refer to sections
10.1-4 and 10.1-5 for navigation instructions.
10.1-9 Hints and Tips
The previous example is one way you can use the Multi-Navigator.
There are many other features you might want for use on your trips. You can, for
example:
! Check MIN / MAX altitude in the ALTITUDE function.
! Check barometric pressure and weather forecast in the BARO function.
! Store positions along your trip as waypoints, in the MARK WAYPOINT function.
! Check ODOMETER and MAX speed, to see how far and fast you have travelled.
! Connect a number of stored waypoints into a route in the ROUTE menu.
! Create new waypoints using the MagniPointer.
! Check your current position in the POSITION function.
! Check your current rate of ascent or descent in the ALTITUDE function.
As you see there are lots of possibilities, so use your imagination.
11 -- Maintenance & Fault Finding
11.1 -- Maintenance
Clean instrument with a mild soap solution.
DO NOT use detergents or high-pressure washing equipment.
11.2 -- Fault Finding
The Multi-Navigator Does Not Switch ON:
Check that you have inserted fresh batteries in the correct direction.
GPS Receiver Cannot Calculate Its Position:
Are you indoors? If so, go out on a fairly open spot and try again. If you are outdoors
check that you have a clear sky. This is especially important when starting the unit for the
first time, or if there has been a long period of time since last use.
Altimeter Displays Incorrect Values:
Calibrate your altimeter. The Altimeter is based on barometric pressure changes. Check
BARO function to monitor changes in barometric pressure.
Weather Forecast is Not Correct:
The weather forecast is based on the history and rate of change in air pressure. This
history is recorded even when the Multi-Navigator is off. It is advisable to have the Multi-
Navigator at a constant altitude for at least 6 hours before reading the weather forecast.
20
Figure 32