Owner`s manual

10.1-2 Recording Ice Lake as a Waypoint
Now that you know the location it is time to store it in your Multi-Navigator.
1. Press WPT and scroll UP until the display shows NEW WAYPOINT.
2. Press YES to set the coordinates of Ice Lake.
3. Adjust the zone number to N 11 and press SET.
4. Enter the Easting and Northing coordinates of Ice Lake using LEFT and RIGHT to
move the cursor and UP and DOWN to change each value.
! The digit adjacent to the E should always be 0.
! For Northing values continue pressing RIGHT until cursor is at the bottom row.
5. Press SET when complete.
6. Now enter the altitude of Ice Lake and press SET.
7. Enter the waypoint name as LAKE and press SET to complete.
8. LAKE is now stored as a waypoint and you are prompted to enter a new waypoint.
9. Press NO and the Multi-Navigator will return to the POSITION function.
10. Turn the unit off.
You are now ready to drive to the trailhead and head to Ice Lake.
10.1-3 Storing Your “HOME” Waypoint
After a the short drive to reach the trailhead, get out of your vehicle and power on your
Multi-Navigator. Once the Multi-Navigator has aquired your position you are
ready to store your *HOME* position at the vehicle.
1. Press and hold WPT until NEW HOME STORED appears.
10.1-4 Navigating to Lake
Now that *HOME* is recorded you are ready to activate the LAKE waypoint.
1. Scroll to the GPS function and press SET.
! GOTO WAYPOINT is displayed, press YES.
2. The first available waypoint is shown. Scroll until LAKE is displayed and press YES.
The bearing, distance, course and speed are now displayed in the GPS navigation
function. Since the GPS function will not work while standing still, it is preferable to use
the COMPASS function for checking the direction.
3. Press COMPASS and the Multi-Navigator points
you towards the LAKE waypoint (Fig. 31)
! Sight a landmark in the correct direction if you
cannot see Ice Lake.
! Remember, hold the Multi-Navigator level by centering the
bubble.
Now turn the Multi-Navigator off and get out there
TM
.
10.1-5 Checking Direction to Ice Lake
When you reach the landmark you are ready to check the direction
again. With power still off press and hold the COMPASS button,
instantly activating the compass function. Using the pointers orient the
Multi-Navigator to the direction of Ice Lake. Sight another landmark in
that direction and release the COMPASS button. Continue your trip.
Note! When using the TrueMagnetic compass function with Multi-Navigator switched
off, the direction and distance to Ice Lake will be based on the last time the GPS
receiver was on. Remember, to get correct information based upon your current
position you need to switch GPS receiver on.
10.1-6 Correct Direction & Distance to Ice Lake
When you have walked for awhile and want an updated position using the GPS receiver
turn the Multi-Navigator on.
1. Once your position has been acquired press COMPASS.
! Distance and direction from your current position to Ice Lake is now updated.
2. Now sight another landmark along the updated course to Ice Lake.
19
Figure 31