Owner`s manual

ROUTE MENU Setting (See section 8-2)
The ROUTE MENU is the sub-menu used to store and manage routes in the Multi-
Navigator. A route is any number of legs connected together. A leg is any two waypoints
connected together. It is possible to store up to 10 routes with 100 waypoints each.
When navigating a route, the Multi-Navigator automatically shifts to the next leg in the
route when you are in line with the leg you were previously traveling. It is not necessary
to manually change to the next leg. It is also possible to reverse a route to return to the
starting point.
8.2 ROUTE MENU
Press YES to enter the ROUTE MENU (Fig. 27).
Use UP and DOWN to scroll through the five menu options.
NEW ROUTE
Note! Several waypoints must be stored before a route can be
created.
1. Press YES to create a route. The ADD WAYPOINT screen will
be displayed.
2. Press YES and scroll to the desired waypoint using UP and
DOWN , then press YES to select that waypoint.
! This is your start waypoint.
3. Repeat this procedure for each additional waypoint.
! The total distance of the route can be displayed by pressing RIGHT or LEFT.
Press button again to return.
4. When final destination waypoint is entered press NO at the ADD WAYPOINT screen.
The display will go back to NEW ROUTE.
ACTIVATE ROUTE
A route must be activated to begin route navigation.
Press YES to select the route you wish to activate.
1. Press UP and DOWN to scroll through the stored routes. Select by pressing YES.
2. Use UP and DOWN to select the direction to navigate the route.
! ACTIVATE FORWARD if you want to navigate the route the way it was stored
(from the start waypoint to the final destination).
! Or select ACTIVATE REVERSED if you want to navigate the route in the opposite
direction (from destination to start).
After activating a route the Multi-Navigator will detect your location on the route and
automatically place you into navigation on the closest leg from your current position.
EDIT ROUTE
Press YES to edit any part of a previously stored route, including adding a new final
destination waypoint, changing a start waypoint, or inserting a waypoint.
1. Search for a route using UP and DOWN. Select by pressing YES.
2. The first leg in the route appears. Scroll with UP and DOWN to find the leg you wish
to edit. Press YES to select.
3. Scroll through possible edit options with UP and DOWN.
! INSERT – inserts a waypoint in between the two waypoints in the leg.
! ADD – adds a new waypoint at the end of the route.
! REPLACE – replaces the target waypoint in the leg.
! REMOVE – removes the target waypoint in the leg.
4. Select the change you wish by pressing YES.
5. Press NO when all changes are complete to save and exit.
16
Figure 27