Operation Manual

11
Treating with Silk’n FaceFX for the First Time
The skin should be, clean, dry and free of any powder, gel or
cream.
If necessary a light oil based serum may be applied thinly to the
skin to help glide the device. Allow serum to absorb into the skin
before treating. See “cleaning the Silk’n FaceFX” section.
Remove Silk’n FaceFX
APPLICATOR from its package.
Press the
POWER ON/OFF SWITCH. The green READY/TREATMENT
INDICATOR LIGHT
(I) will start blinking, and shortly afterwards will
be lit steadily.
Your FaceFX is ready for treatment.
Place the
TREATMENT SURFACE on your skin. The LED light will
automatically activate.
Apply light pressure while slowly moving the FaceFX
APPLICATOR in small circular motions. The
TREATMENT SURFACE
temperature will slowly increase.
Perform the treatment
for 5-7 minutes on each
area.
It is recommended to
apply a small amount of
a moisturizing cream on
the treated skin areas
after each session and
to massage it gently in
circular motions.