Reference Manual

RS9116 n-Link Linux and Android Technical Reference Manual
Version 2.0
August 2019
63
#. /wpa_cli –i <vap_name> wps_pin <sta_mac_addr>
This will generate a 4/8-digit numeric WPS PIN.
 7. Enter the PIN on the STA.
 8. Wait for the STA to parse all the WPS Access Points.
Note:
1. WPS_PIN and passphrase are different.
2. WPS connection timeout is 120 seconds
3. 3
rd
party Stations usually try to connect to all scanned WPS Access Points until they succeed in connecting to
one of them.
4. WPS can be used along with any of the Secure modes (except WEP) and also with Open mode.
5.5.1.2 Client Mode
The steps for configuring WPS in Client mode are as follows:
1. Start the driver in Client mode.
2. Start the supplicant by entering the following command.
# ./wpa_supplicant –i <vap_name> -D bsd –c <wps_conf_file> -ddddt
 3. For Push Button method:
• Push the button on the Access Point
• Enter the command below for the n-Link® STA
# ./wpa_cli –i <vap_name> wps_pbc <bssid>
Note:
This is the Access Point's MAC address. If the BSSID is not known, the input parameter will be
the string named "any".
• Wait for the STA to parse all the WPS Access Points.
 4. For Enter PIN method,
• Click on "Generate PIN" on the Access Point. A 4/8-digit numeric WPS PIN is generated.
• Enter the command below for the n-Link® STA
# ./wpa_cli –i <vap_name> wps_pin <bssid> <wps_pin>
a. Wait for the STA to parse all the WPS Access Points.
 5. For Generate PIN method,
• Enter the command below for the n-Link® STA