Reference Manual

RS9116 n-Link Linux and Android Technical Reference Manual
Version 2.0
August 2019
61
Get Tx-Power
Description This command is used to get current value of transmit power
from firmware and updates it in iwconfig command.
Default Value -
Input Parameters -
Output Parameter None
Reset Required No
Usage # ./onebox_util <base_interface> get_txpwr
Example ./onebox_util rpine0 get_txpwr
Useonly rates
Description This command is used set the supported rates in AP mode. This
will be helpfull to control the transmit data rates of the clients
connected.
Default Value All rates supported as per regulatory domain.
Input Prameters Integer value as per the mapping below:
1 Mbps – 2
2 Mbps – 4
5.5 Mbps – 11
11 Mbps – 22
6 Mbps – 12
12 Mbps – 24
Output Parameters None
Reset Required No
Usage # ./onebox_util <base_interface> useonly_rates <rate_val>
<rate_val> <rate_val>
Example ./onebox_util rpine0 useonly_rates 2 11 12
Table 5: Usage of onebox util
5.5.1 WPS Configuration
Wi-Fi Protected Setup (WPS) is a standard for easy and secure wireless network setup and connections. The
Onebox-Mobile supports the following configuration methods:
• Push Button Method
• PIN Method – Enter and Generate
A WPS Configuration file is used for setting up a connection with a remote Access Point or Station. A sample WPS
configuration file is given below for reference.