Reference Manual
Table Of Contents
- Introduction to RS9116
- Getting Started with RS9116
- Compiling the Driver
- Installing the Driver
- Installation of Modules
- Enabling a Protocol
- Disabling a Protocol
- OneBox-Mobile in Wi-Fi Only Mode
- Installation in Wi-Fi Client Mode (with BSD interface support)
- Installation in Access Point Mode (with BSD interface support)
- Installation in Wi-Fi Client Mode (with NL80211 support)
- Installation in Wi-Fi AP mode (with NL80211 support)
- Installation in Wi-Fi Direct Mode (With BSD Interface Support)
- Installation in Wi-Fi Direct Mode (With NL80211 Support only for Kernel v3.8 or higher)
- OneBox-Mobile in Wi-Fi + Bluetooth LE Coexistence Mode
- Driver Information
- Wi-Fi ioctl Usage Guide
- Configuration Using CFG80211
- Enterprise security using CFG80211
- HOSTAPD and Wi-Fi Protected Setup (WPS)
- ACS with Hostapd
- Antenna Diversity
- Sniffer Mode
- Monitor Mode
- Concurrent Mode
- Background Scan Parameters
- Power save Modes, Profiles and Parameters
- Compliance and Certification
- Wi-Fi Performance Test ioctl usage
- Wake-On-Wireless LAN
- PUF [ Physical Unclonable Functions ]
- GTK Offload
- Steps to connect 802.11R client to AP
- Steps to configure 802.11W
- Update WLAN region based maximum powers from driver
- Bluetooth hcitool and hciconfig Usage
- Android support for RS9116
- Appendix A: Configuration of Kernels from 3.13 and above
- Appendix B: Binary Files for Embedded Platforms
- Appendix C: Using the Bluetooth Manager
- Appendix D: Common Configuration Parameters
- Appendix E: Installation of Missing Generic Netlink Libraries
- Appendix F: Procedure to use latest supplicant with NL80211 interface
- Appendix G: Considerations need to be made during hostapd usage
- RS9116 n-Link Software TRM Revision History
RS9116 n-Link Linux and Android Technical Reference Manual
Version 2.0
August 2019
50
Set SSID for Background
Scan (only in Client mode)
Description This command is used to set the SSID of the Hidden Access
Point (SSID not being broadcast) during Background Scan.
Default Value -
Input Parameters Base Interface (string like rpine0)
SSID (max. 32 characters)
Output Parameter None
Reset Required No.
Usage # ./onebox_util <base_interface> bgscan_ssid <ssid>
Example The command below sets the SSID of a Hidden Access Point
during Background Scan.
# ./onebox_util rpine0 bgscan_ssid REDPINE_AP
Note:The bgscan_ssid command has to be followed by the
set_bgscan_params or do_bgscan command in
order for the Probe Request to be sent with the SSID requested
in the bgscan_ssid command.
Enable Power Save and Set
Parameters (only in Client
mode)
Description This command is used to enable/disable power save modes and
set the required power save mode for the n-Link® module. Refer
to the sectionPower save Modes, Profiles and Parameters for
more details on each parameter and their usage.
Default Value -