Reference Manual
Table Of Contents
- Introduction to RS9116
- Getting Started with RS9116
- Compiling the Driver
- Installing the Driver
- Installation of Modules
- Enabling a Protocol
- Disabling a Protocol
- OneBox-Mobile in Wi-Fi Only Mode
- Installation in Wi-Fi Client Mode (with BSD interface support)
- Installation in Access Point Mode (with BSD interface support)
- Installation in Wi-Fi Client Mode (with NL80211 support)
- Installation in Wi-Fi AP mode (with NL80211 support)
- Installation in Wi-Fi Direct Mode (With BSD Interface Support)
- Installation in Wi-Fi Direct Mode (With NL80211 Support only for Kernel v3.8 or higher)
- OneBox-Mobile in Wi-Fi + Bluetooth LE Coexistence Mode
- Driver Information
- Wi-Fi ioctl Usage Guide
- Configuration Using CFG80211
- Enterprise security using CFG80211
- HOSTAPD and Wi-Fi Protected Setup (WPS)
- ACS with Hostapd
- Antenna Diversity
- Sniffer Mode
- Monitor Mode
- Concurrent Mode
- Background Scan Parameters
- Power save Modes, Profiles and Parameters
- Compliance and Certification
- Wi-Fi Performance Test ioctl usage
- Wake-On-Wireless LAN
- PUF [ Physical Unclonable Functions ]
- GTK Offload
- Steps to connect 802.11R client to AP
- Steps to configure 802.11W
- Update WLAN region based maximum powers from driver
- Bluetooth hcitool and hciconfig Usage
- Android support for RS9116
- Appendix A: Configuration of Kernels from 3.13 and above
- Appendix B: Binary Files for Embedded Platforms
- Appendix C: Using the Bluetooth Manager
- Appendix D: Common Configuration Parameters
- Appendix E: Installation of Missing Generic Netlink Libraries
- Appendix F: Procedure to use latest supplicant with NL80211 interface
- Appendix G: Considerations need to be made during hostapd usage
- RS9116 n-Link Software TRM Revision History
RS9116 n-Link Linux and Android Technical Reference Manual
Version 2.0
August 2019
38
Input Parameters Zone value.
The integer value mapping has been shown below:
0 – Disable zone.
0x4000 – Error Zone.
Output Parameter None
Reset Required No
Usage # iwpriv <vap name> set_dbg_zone <zone_value>
Example The following command disables debug zone level.
# iwpriv wifi0 set_dbg_zone 0
Table 2: iwpriv Usage for Access Point and Client Modes
5.3 Private (Driver- Specific) Commands for Access Point Mode
The table below describes the usage of the "iwpriv" command for setting and getting parameters common for the
Access Point Mode.
Set DTIM Period
Description This command is used to set the DTIM period in the n-Link® Module.
Issue this command before starting the supplicant.
Default Value 1
Input Parameters VAP Name (string like wifi0, wifi1, etc.)
Integer value between 1 and 15
Output Parameter None
Reset Required Yes. In order to set the DTIM period, the virtual interface has to be
reset.
Usage
1. iwpriv <vap_name> dtim_period <value>