Reference Manual
Table Of Contents
- Introduction to RS9116
- Getting Started with RS9116
- Compiling the Driver
- Installing the Driver
- Installation of Modules
- Enabling a Protocol
- Disabling a Protocol
- OneBox-Mobile in Wi-Fi Only Mode
- Installation in Wi-Fi Client Mode (with BSD interface support)
- Installation in Access Point Mode (with BSD interface support)
- Installation in Wi-Fi Client Mode (with NL80211 support)
- Installation in Wi-Fi AP mode (with NL80211 support)
- Installation in Wi-Fi Direct Mode (With BSD Interface Support)
- Installation in Wi-Fi Direct Mode (With NL80211 Support only for Kernel v3.8 or higher)
- OneBox-Mobile in Wi-Fi + Bluetooth LE Coexistence Mode
- Driver Information
- Wi-Fi ioctl Usage Guide
- Configuration Using CFG80211
- Enterprise security using CFG80211
- HOSTAPD and Wi-Fi Protected Setup (WPS)
- ACS with Hostapd
- Antenna Diversity
- Sniffer Mode
- Monitor Mode
- Concurrent Mode
- Background Scan Parameters
- Power save Modes, Profiles and Parameters
- Compliance and Certification
- Wi-Fi Performance Test ioctl usage
- Wake-On-Wireless LAN
- PUF [ Physical Unclonable Functions ]
- GTK Offload
- Steps to connect 802.11R client to AP
- Steps to configure 802.11W
- Update WLAN region based maximum powers from driver
- Bluetooth hcitool and hciconfig Usage
- Android support for RS9116
- Appendix A: Configuration of Kernels from 3.13 and above
- Appendix B: Binary Files for Embedded Platforms
- Appendix C: Using the Bluetooth Manager
- Appendix D: Common Configuration Parameters
- Appendix E: Installation of Missing Generic Netlink Libraries
- Appendix F: Procedure to use latest supplicant with NL80211 interface
- Appendix G: Considerations need to be made during hostapd usage
- RS9116 n-Link Software TRM Revision History
RS9116 n-Link Linux and Android Technical Reference Manual
Version 2.0
August 2019
36
Output Parameter None
Reset Required No
Usage # iwpriv <vap_name> wmm <value>
Example The command below sets the WMM mode for the module:
# iwpriv wifi0 wmm 1
Note: Issue this command before starting the supplicant in Access Point
Mode.
Set AMPDU
Description This command is used to enable AMPDU Aggregation in the n-Link®
Module
Default Value -
Input Parameters VAP Name (string like wifi0, wifi1, etc.)
The integer value mapping has been shown below:
0 – Disable AMPDU Aggregation
1 – Enable AMPDU Aggregation for Transmit, disable for Receive
2 – Enable AMPDU Aggregation for Receive, disable for Transmit
Output Parameter None
Reset Required No
Usage # iwpriv <vap_name> ampdu_set <value>
Example The command given below disables A-MPDU aggregation:
# iwpriv wifi0 ampdu_set 0
The command given below enables A-MPDU aggregation for Transmit:
# iwpriv wifi0 ampdu_set 1
Set Bandwidth
Description This command is used to enable or disable 20/40 MHz Bandwidths in the
n-Link® Module.
Default Value -