Reference Manual
Table Of Contents
- Introduction to RS9116
- Getting Started with RS9116
- Compiling the Driver
- Installing the Driver
- Installation of Modules
- Enabling a Protocol
- Disabling a Protocol
- OneBox-Mobile in Wi-Fi Only Mode
- Installation in Wi-Fi Client Mode (with BSD interface support)
- Installation in Access Point Mode (with BSD interface support)
- Installation in Wi-Fi Client Mode (with NL80211 support)
- Installation in Wi-Fi AP mode (with NL80211 support)
- Installation in Wi-Fi Direct Mode (With BSD Interface Support)
- Installation in Wi-Fi Direct Mode (With NL80211 Support only for Kernel v3.8 or higher)
- OneBox-Mobile in Wi-Fi + Bluetooth LE Coexistence Mode
- Driver Information
- Wi-Fi ioctl Usage Guide
- Configuration Using CFG80211
- Enterprise security using CFG80211
- HOSTAPD and Wi-Fi Protected Setup (WPS)
- ACS with Hostapd
- Antenna Diversity
- Sniffer Mode
- Monitor Mode
- Concurrent Mode
- Background Scan Parameters
- Power save Modes, Profiles and Parameters
- Compliance and Certification
- Wi-Fi Performance Test ioctl usage
- Wake-On-Wireless LAN
- PUF [ Physical Unclonable Functions ]
- GTK Offload
- Steps to connect 802.11R client to AP
- Steps to configure 802.11W
- Update WLAN region based maximum powers from driver
- Bluetooth hcitool and hciconfig Usage
- Android support for RS9116
- Appendix A: Configuration of Kernels from 3.13 and above
- Appendix B: Binary Files for Embedded Platforms
- Appendix C: Using the Bluetooth Manager
- Appendix D: Common Configuration Parameters
- Appendix E: Installation of Missing Generic Netlink Libraries
- Appendix F: Procedure to use latest supplicant with NL80211 interface
- Appendix G: Considerations need to be made during hostapd usage
- RS9116 n-Link Software TRM Revision History
RS9116 n-Link Linux and Android Technical Reference Manual
Version 2.0
August 2019
35
Output Parameter The integer value mapping has been shown below:
0 – Disable Short GI
32 – Enable Short GI for 20MHz Bandwidth
64 – Enable Short GI for 40MHz Bandwidth
96 – Enable Short GI for 20MHz and 40MHz Bandwidths
Reset Required No
Usage # iwpriv <vap_name> get_short_gi
Example The command given below explains about getting the Short GI
programmed in the module:
# iwpriv wifi0 get_short_gi
Get Privacy
Description This command is used to get the Privacy bit of the n-Link® Module
Default Value -
Input Parameters VAP Name (string like wifi0, wifi1, etc.)
Output Parameter The integer value mapping has been shown below:
0 – Privacy is disabled
1 – Privacy is enabled
Reset Required No
Usage # iwpriv <vap_name> get_privacy
Example The command given below tells about like how to get the Privacy
information in the module:
# iwpriv wifi0 get_privacy
Set WMM (only in Access Point mode)
Description This command is used to enable the WMM (QoS) feature of the n-Link®
Module
Default Value 1 (Enabled)
Input Parameters VAP Name (string like wifi0, wifi1, etc.)
The integer value mapping has been shown below:
0 – Disable
1 – Enable