Reference Manual

RS9116 n-Link Linux and Android Technical Reference Manual
Version 2.0
August 2019
32
Input Parameters VAP Name (string like wifi0, wifi1, etc.)
Integer value as per the mapping below:
Auto Rate – 0
1 Mbps – 2
2 Mbps – 4
5.5 Mbps – 11
11 Mbps – 22
6 Mbps – 12
12 Mbps – 24
18 Mbps – 36
24 Mbps – 48
36 Mbps – 72
48 Mbps – 96
54 Mbps – 108
MCS0 – 13
MCS1 – 26
MCS2 – 39
MCS3 – 52
MCS4 – 78
MCS5 – 104
MCS6 – 117
MCS7 – 130
Output Parameter None
Reset required No
Usage # iwconfig <vap_name> rate <rate_val>
Note: For Access Point mode, this command has to be issued after the Set
Mode command only if the VAP has started using “iwconfig” commands and
not using the supplicant provided by Redpine Signals. For Client mode, the
Set Mode command is not mandatory
Set RTS/CTS Threshold (only in Access Point mode)
Description This command is used to set the RTS/CTS threshold of the n-Link® Module.