Reference Manual
Table Of Contents
- Introduction to RS9116
- Getting Started with RS9116
- Compiling the Driver
- Installing the Driver
- Installation of Modules
- Enabling a Protocol
- Disabling a Protocol
- OneBox-Mobile in Wi-Fi Only Mode
- Installation in Wi-Fi Client Mode (with BSD interface support)
- Installation in Access Point Mode (with BSD interface support)
- Installation in Wi-Fi Client Mode (with NL80211 support)
- Installation in Wi-Fi AP mode (with NL80211 support)
- Installation in Wi-Fi Direct Mode (With BSD Interface Support)
- Installation in Wi-Fi Direct Mode (With NL80211 Support only for Kernel v3.8 or higher)
- OneBox-Mobile in Wi-Fi + Bluetooth LE Coexistence Mode
- Driver Information
- Wi-Fi ioctl Usage Guide
- Configuration Using CFG80211
- Enterprise security using CFG80211
- HOSTAPD and Wi-Fi Protected Setup (WPS)
- ACS with Hostapd
- Antenna Diversity
- Sniffer Mode
- Monitor Mode
- Concurrent Mode
- Background Scan Parameters
- Power save Modes, Profiles and Parameters
- Compliance and Certification
- Wi-Fi Performance Test ioctl usage
- Wake-On-Wireless LAN
- PUF [ Physical Unclonable Functions ]
- GTK Offload
- Steps to connect 802.11R client to AP
- Steps to configure 802.11W
- Update WLAN region based maximum powers from driver
- Bluetooth hcitool and hciconfig Usage
- Android support for RS9116
- Appendix A: Configuration of Kernels from 3.13 and above
- Appendix B: Binary Files for Embedded Platforms
- Appendix C: Using the Bluetooth Manager
- Appendix D: Common Configuration Parameters
- Appendix E: Installation of Missing Generic Netlink Libraries
- Appendix F: Procedure to use latest supplicant with NL80211 interface
- Appendix G: Considerations need to be made during hostapd usage
- RS9116 n-Link Software TRM Revision History
RS9116 n-Link Linux and Android Technical Reference Manual
Version 2.0
August 2019
120
./ble_transmit 71764129 250 1 38 38 0 0 0 1 10 0 0 3 0 0 1 3
For transmitting a BLE-1Mbps Advertising packet with Access Address of 0x71764129 and packet length of 250bytes
on 2478MHz with the following parameters
Access_Addr - 71764129
pkt_length - 250
ble_rate - 1
rx_channel_index -38
tx_channel_index -38
scrambler_seed - 0
no_of_packets - 0
payload_type - 0
le_channel_type -1
tx_power - 10
tx_mode - 0
hopping_type - 0
ant_sel -3
inter_pkt_gap -0
pll_mode -0
rf_type - 1
rf_chain - 3
24.4 BLE/BLR Receive
24.4.1 Introduction
The "receive" utility, present in the "release" folder requires configuring the following parameters to start
transmitting packets.
• Access Address
• Data Length indication
• Scrambler_seed
• ble_rate
• Receive channel index
• Transmit_channel index
• LE Channel type
• hopping type
• Antenna selection
• Loop_back_mode enable/disable
• pwrsave_options
• pll_mode
• rf_type
• rf_chain
Please stop the transmission before you start again using the command below :
. /ble_transmit 0