Data Sheet
Table Of Contents
- 1. Feature List
- 2. Ordering Information
- 3. System Overview
- 4. Electrical Characteristics
- 4.1 Absolute Maximum Ratings
- 4.2 General Operating Conditions
- 4.3 MCU Current Consumption with 3 V Supply
- 4.4 Radio Current Consumption with 3 V Supply
- 4.5 RF Transmitter General Characteristics for the 2.4 GHz Band
- 4.6 RF Receiver General Characteristics for the 2.4 GHz Band
- 4.7 RF Receiver Characteristics for Bluetooth Low Energy in the 2.4 GHz Band 1 Mbps Data Rate
- 4.8 RF Receiver Characteristics for Bluetooth Low Energy in the 2.4 GHz Band 2 Mbps Data Rate
- 4.9 RF Receiver Characteristics for Bluetooth Low Energy in the 2.4 GHz Band 500 kbps Data Rate
- 4.10 RF Receiver Characteristics for Bluetooth Low Energy in the 2.4 GHz Band 125 kbps Data Rate
- 4.11 High-Frequency Crystal
- 4.12 Low-Frequency Crystal
- 4.13 Precision Low Frequency RC Oscillator (LFRCO)
- 4.14 GPIO Pins
- 4.15 Microcontroller Peripherals
- 4.16 Typical Performance Curves
- 5. Reference Diagrams
- 6. Pin Definitions
- 7. Design Guidelines
- 8. Package Specifications
- 9. Soldering Recommendations
- 10. Tape and Reel
- 11. Certifications
- 12. Revision History
Confidential
Class B Device Notice
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular in-
stallation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
BGM220P Wireless Gecko Bluetooth Module Data Sheet
Certifications
silabs.com | Building a more connected world. Preliminary Rev. 0.5 | 42