User manual
...the world's most energy friendly microcontrollers
2012-04-24 - Giant Gecko Family - d0053_Rev0.96 600
www.energymicro.com
Bit Name Reset Access Description
Set when the value written to LETIMERn_COMP0 is being synchronized.
1 CMD 0 R LETIMERn_CMD Register Busy
Set when the value written to LETIMERn_CMD is being synchronized.
0 CTRL 0 R LETIMERn_CTRL Register Busy
Set when the value written to LETIMERn_CTRL is being synchronized.
23.5.15 LETIMERn_ROUTE - I/O Routing Register
Offset Bit Position
0x040
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Reset
0x0
0
0
Access
RW
RW
RW
Name
LOCATION
OUT1PEN
OUT0PEN
Bit Name Reset Access Description
31:11 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
10:8 LOCATION 0x0 RW I/O Location
Decides the location of the LETIMER I/O pins
Value Mode Description
0 LOC0 Location 0
1 LOC1 Location 1
2 LOC2 Location 2
3 LOC3 Location 3
7:2 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
1 OUT1PEN 0 RW Output 1 Pin Enable
When set, output 1 of the LETIMER is enabled
Value Description
0 The LETn_O1 pin is disabled
1 The LETn_O1 pin is enabled
0 OUT0PEN 0 RW Output 0 Pin Enable
When set, output 0 of the LETIMER is enabled
Value Description
0 The LETn_O0 pin is disabled
1 The LETn_O0 pin is enabled