User manual
...the world's most energy friendly microcontrollers
2012-04-24 - Giant Gecko Family - d0053_Rev0.96 553
www.energymicro.com
20.5.19 TIMERn_DTOGEN - DTI Output Generation Enable Register
Offset Bit Position
0x07C
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Reset
0
0
0
0
0
0
Access
RW
RW
RW
RW
RW
RW
Name
DTOGCDTI2EN
DTOGCDTI1EN
DTOGCDTI0EN
DTOGCC2EN
DTOGCC1EN
DTOGCC0EN
Bit Name Reset Access Description
31:6 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
5 DTOGCDTI2EN 0 RW DTI CDTI2 Output Generation Enable
This bit enables/disables output generation for the CDTI2 output from the DTI.
4 DTOGCDTI1EN 0 RW DTI CDTI1 Output Generation Enable
This bit enables/disables output generation for the CDTI1 output from the DTI.
3 DTOGCDTI0EN 0 RW DTI CDTI0 Output Generation Enable
This bit enables/disables output generation for the CDTI0 output from the DTI.
2 DTOGCC2EN 0 RW DTI CC2 Output Generation Enable
This bit enables/disables output generation for the CC2 output from the DTI.
1 DTOGCC1EN 0 RW DTI CC1 Output Generation Enable
This bit enables/disables output generation for the CC1 output from the DTI.
0 DTOGCC0EN 0 RW DTI CC0 Output Generation Enable
This bit enables/disables output generation for the CC0 output from the DTI.
20.5.20 TIMERn_DTFAULT - DTI Fault Register
Offset Bit Position
0x080
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Reset
0
0
0
0
Access
R
R
R
R
Name
DTLOCKUPF
DTDBGF
DTPRS1F
DTPRS0F
Bit Name Reset Access Description
31:4 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
3 DTLOCKUPF 0 R DTI Lockup Fault
This bit is set to 1 if a core lockup fault has occurred and DTLOCKUPFEN is set to 1. The TIMER0_DTFAULTC register can be
used to clear fault bits.
2 DTDBGF 0 R DTI Debugger Fault
This bit is set to 1 if a debugger fault has occurred and DTDBGFEN is set to 1. The TIMER0_DTFAULTC register can be used to
clear fault bits.
1 DTPRS1F 0 R DTI PRS 1 Fault
This bit is set to 1 if a PRS 1 fault has occurred and DTPRS1FEN is set to 1. The TIMER0_DTFAULTC register can be used to
clear fault bits.