User manual
...the world's most energy friendly microcontrollers
2012-04-24 - Giant Gecko Family - d0053_Rev0.96 550
www.energymicro.com
Bit Name Reset Access Description
31:16 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
15:0 CCVB 0x0000 RWH CC Channel Value Buffer
In Input Capture mode, this field holds the last capture value if the TIMERn_CCx_CCV register already contains an earlier unread
capture value. In Output Compare or PWM mode, this field holds the CC buffer value which will be written to TIMERn_CCx_CCV
on an update event if TIMERn_CCx_CCVB contains valid data.
20.5.16 TIMERn_DTCTRL - DTI Control Register
Offset Bit Position
0x070
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Reset
0
0x0
0
0
0
0
Access
RW
RW
RW
RW
RW
RW
Name
DTPRSEN
DTPRSSEL
DTCINV
DTIPOL
DTDAS
DTEN
Bit Name Reset Access Description
31:25 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
24 DTPRSEN 0 RW DTI PRS Source Enable
Enable/disable PRS as DTI input.
23:8 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
7:4 DTPRSSEL 0x0 RW DTI PRS Source Channel Select
Select which PRS channel to listen to.
Value Mode Description
0 PRSCH0 PRS Channel 0 selected as input
1 PRSCH1 PRS Channel 1 selected as input
2 PRSCH2 PRS Channel 2 selected as input
3 PRSCH3 PRS Channel 3 selected as input
4 PRSCH4 PRS Channel 4 selected as input
5 PRSCH5 PRS Channel 5 selected as input
6 PRSCH6 PRS Channel 6 selected as input
7 PRSCH7 PRS Channel 7 selected as input
8 PRSCH8 PRS Channel 8 selected as input
9 PRSCH9 PRS Channel 9 selected as input
10 PRSCH10 PRS Channel 10 selected as input
11 PRSCH11 PRS Channel 11 selected as input
3 DTCINV 0 RW DTI Complementary Output Invert.
Set to invert complementary outputs.
2 DTIPOL 0 RW DTI Inactive Polarity
Set inactive polarity for outputs.
1 DTDAS 0 RW DTI Automatic Start-up Functionality
Configure DTI restart on debugger exit.
Value Mode Description
0 NORESTART No DTI restart on debugger exit
1 RESTART DTI restart on debugger exit
0 DTEN 0 RW DTI Enable
Enable/disable DTI.