User manual

...the world's most energy friendly microcontrollers
2012-04-24 - Giant Gecko Family - d0053_Rev0.96 511
www.energymicro.com
19.5.9 LEUARTn_RXDATAXP - Receive Buffer Data Extended Peek
Register
Offset Bit Position
0x020
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
9 8 7 6 5 4 3 2 1 0
Reset
0 0
0x000
Access
R R R
Name
FERRP PERRP
RXDATAP
Bit Name Reset Access Description
31:16 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
15 FERRP 0 R Receive Data Framing Error Peek
Set if data in buffer has a framing error. Can be the result of a break condition.
14 PERRP 0 R Receive Data Parity Error Peek
Set if data in buffer has a parity error.
13:9 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
8:0 RXDATAP 0x000 R RX Data Peek
Use this register to access data read from the LEUART.
19.5.10 LEUARTn_TXDATAX - Transmit Buffer Data Extended Register
(Async Reg)
For more information about Asynchronous Registers please see Section 5.3 (p. 20) .
Offset Bit Position
0x024
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10
9 8 7 6 5 4 3 2 1 0
Reset
0 0 0
0x000
Access
W W W W
Name
RXENAT
TXDISAT TXBREAK
TXDATA
Bit Name Reset Access Description
31:16 Reserved
To ensure compatibility with future devices, always write bits to 0. More information in Section 2.1 (p. 3)
15 RXENAT 0 W Enable RX After Transmission
Set to enable reception after transmission.
Value Description
0 -
1 The receiver is enabled, setting RXENS after the frame has been transmitted
14 TXDISAT 0 W Disable TX After Transmission
Set to disable transmitter directly after transmission has competed.
Value Description
0 -