User's Guide
Table Of Contents
- 2 Introduction
- 3 Firmware
- 4 Quick Start
- 5 Operating Modes
- 6 Hardware
- 7 Contacts
- 8 Disclaimers
- 8.1 FCC Interference Statement (Part 15.105 (b))
- 8.2 FCC Part 15 Clause 15.21
- 8.3 FCC Part 15.19(a) [interference compliance statement], unless the following statement is already provided on the device label
- 8.4 ISED RSS-Gen Notice
- 8.5 FCC RF Exposure Guidance Statement
- 8.6 ISED RF Exposure Guidance Statement
- 9 Version History
BAT-X
5500 TRABUCCO ROAD SUITE 150, IRVINE, CALIFORNIA 92620
P: +1 (949) 748-8895
E: info@mobilogix.com
© MOBILOGIX, INC.
8.4 ISED RSS-GEN NOTICE
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’encompromettre le
fonctionnement.
8.5 FCC RF EXPOSURE GUIDANCE STATEMENT
In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from
the human body at all times.
8.6 ISED RF EXPOSURE GUIDANCE STATEMENT
In order to comply with FCC/ISED RF Exposure requirements, this device must be installed to provide at least 20 cm separation from
the human body at all times.
Afin de se conformer aux exigences d'exposition RF FCC / ISED, cet appareil doit être installé pour fournir au moins 20 cm de
séparation du corps humain en tout temps.
9 VERSION HISTORY
Date
Description
2020-06-16
Initial document version.
2020-06-19
Disclaimers included.