Specifications

AN93
52 Rev. 0.9
80 MNP2 protocol PROTOCOL:
ALTERNATE, +CLASS 2
Set with \V command.
81 MNP3 protocol PROTOCOL:
ALTERNATE, +CLASS 3
Set with \V command.
82 MNP4 protocol PROTOCOL:
ALTERNATE, +CLASS 4
Set with \V command.
83 MNP5 protocol PROTOCOL:
ALTERNATE, +CLASS 5
5
Set with \V command.
84 V.44 protocol PROTOCOL: V.44
7
Set with +DR command
90 Link established at 38666 CONNECT 38666
3
XXXX X
91 Link established at 40000 CONNECT 40000
3
XXXX X
92 Link established at 41333 CONNECT 41333
3
XXXX X
93 Link established at 42666 CONNECT 42666
3
XXXX X
94 Link established at 44000 CONNECT 44000
3
XXXX X
95 Link established at 45333 CONNECT 45333
3
XXXX X
96 Link established at 46666 CONNECT 46666
3
XXXX X
97 Link established at 49333 CONNECT 49333
3
XXXX X
98 Link established at 50666 CONNECT 50666
3
XXXX X
99 Link established at 52000 CONNECT 52000
3
XXXX X
100 Link established at 53333 CONNECT 53333
3
XXXX X
101 Link established at 54666 CONNECT 54666
3
XXXX X
102 DTMF dial attempted on a
pulse dial only line
UN-OBTAINABLE NUMBER X X X X X X
Table 22. Result Codes (Continued)
Numeric
4
Meaning Verbal Response X0 X1 X2 X3 X4 X5
Notes:
1. This message is only supported on the Si2493, Si2457 and Si2434.
2. X is the only verbal response code that does not follow the <CR><LF>Result Code<CR><LF> standard. There is no
leading <CR><LF>.
3. This message is only supported on the Si2493 and Si2457.
4. Numeric mode: Result code <CR>.
5. This message is only supported on the Si2493, Si2457, Si2434, and Si2415.
6. V.44 with data compression disabled (+DS = 0) emits this result code.
7. Protocol :V42 message is sent if data compression is disabled (+DS = Q).