Specifications

AN93
Rev. 0.9 51
32 UK CID State Tone Alert
Signal detected
STAS XXXXX X
33 Overcurrent condition X
2
XXXXX X
40 Blacklist is full BLACKLIST FULL (enabled
via S42 register)
XXXXX X
41 Attempted number is black-
listed.
BLACKLISTED (enabled via
S42 register)
XXXXX X
42 No phone line present NO LINE (enabled via %Vn
commands)
XXXXX X
43 Telephone line is in use LINE IN USE (enabled via
%Vn commands)
XXXXX X
44 Polarity reversal detected POLARITY REVERSAL
(enabled via G modifier)
XXXXX X
45 Polarity reversal NOT
detected
NO POLARITY REVERSAL
(enabled via G modifier)
XXXXX X
52 Link established at 56000 CONNECT 56000
3
XXXX X
60 Link established at 32000 CONNECT 32000
3
XXXX X
61 Link established at 48000 CONNECT 48000
3
XXXX X
63 Link established at 28000 CONNECT 28000
3
XXXX X
64 Link established at 29333 CONNECT 29333
3
XXXX X
65 Link established at 30666 CONNECT 30666
3
XXXX X
66 Link established at 33333 CONNECT 33333
3
XXXX X
67 Link established at 34666 CONNECT 34666
3
XXXX X
68 Link established at 36000 CONNECT 36000
3
XXXX X
69 Link established at 37333 CONNECT 37333
3
XXXX X
70 No protocol PROTOCOL: NONE Set with \V0 command.
75 Link established at 75 CONNECT 75 X X X X X
77 V.42 protocol PROTOCOL: V42
6
Set with \V0 command.
79 V.42bis protocol PROTOCOL: V42bis
5
Set with \V0 command.
Table 22. Result Codes (Continued)
Numeric
4
Meaning Verbal Response X0 X1 X2 X3 X4 X5
Notes:
1. This message is only supported on the Si2493, Si2457 and Si2434.
2. X is the only verbal response code that does not follow the <CR><LF>Result Code<CR><LF> standard. There is no
leading <CR><LF>.
3. This message is only supported on the Si2493 and Si2457.
4. Numeric mode: Result code <CR>.
5. This message is only supported on the Si2493, Si2457, Si2434, and Si2415.
6. V.44 with data compression disabled (+DS = 0) emits this result code.
7. Protocol :V42 message is sent if data compression is disabled (+DS = Q).