Specifications

Si2457/Si2434/Si2415
Rev. 0.91 35
Table 13. Result Codes
Numeric Meaning Verbal Response X0 X1 X2 X3 X4 X5
0Command was successfulOK XXXXXX
1 Link established at 300 bps
or higher
CONNECT XXXXXX
2Incoming ring detected RING XXXXXX
3Link dropped NO CARRIER XXXXXX
4Command failed ERROR XXXXXX
5Link establish at 1200 CONNECT 1200 XXXXX
6 Dial tone not present NO DIALTONE X X X
7 Line busy BUSY X X X
8Remote not answering NO ANSWER XXXXXX
9 Ringback detected RINGING X
10Link established at 2400CONNECT 2400 XXXXX
11Link established at 4800CONNECT 4800 XXXXX
12Link established at 9600CONNECT 9600 XXXXX
14 Link established at 19200 CONNECT 19200
1
XXXXX
15Link established at 7200CONNECT 7200 XXXXX
16Link established at 12000CONNECT 12000 XXXXX
17Link established at 14400CONNECT 14400 XXXXX
18 Link established at 16800 CONNECT 16800
1
XXXXX
19 Link established at 21600 CONNECT 21600
1
XXXXX
20 Link established at 24000 CONNECT 24000
1
XXXXX
21 Link established at 26400 CONNECT 26400
1
XXXXX
22 Link established at 28800 CONNECT 28800
1
XXXXX
23 Link established at 31200 CONNECT 31200
1
XXXXX
24 Link established at 33600 CONNECT 33600
1
XXXXX
30Caller ID mark detected CIDM XXXXXX
31Hookswitch flash detectedFLASH XXXXXX
32 UK CID State Tone Alert
Signal detected
STAS XXXXXX
33 Overcurrent condition X
2
XXXXXX
40 Blacklist is full BLACKLIST FULL (enabled
via S42 register)
XXXXXX
41 Attempted number is black-
listed.
BLACKLISTED (enabled via
S42 register)
XXXXXX
42 No phone line present NO LINE (enabled via %Vn
commands)
XXXXXX
Notes:
1. This message is only supported on the Si2457 and Si2434.
2. X is the only verbal response code that does not follow the <CR><LF>Result Code<CR><LF> standard. There is no
leading <CR><LF>.
3. This message is only supported on the Si2457.