Specifications

AN93
38 Rev. 0.8
+PMHT=X Controls access to MOH request and sets the timeout value.
X
Mode
0 Deny V.92 MOH request.
1 Grant MOH with 10 s timeout.
2 Grant MOH with 20 s timeout.
3 Grant MOH with 30 s timeout.
4 Grant MOH with 40 s timeout.
5 Grant MOH with 1 min. timeout.
6 Grant MOH with 2 min. timeout.
7 Grant MOH with 3 min. timeout.
8 Grant MOH with 4 min. timeout.
9 Grant MOH with 6 min. timeout.
10 Grant MOH with 8 min. timeout.
11 Grant MOH with 12 min. timeout.
12 Grant MOH with 16 min. timeout.
13 Grant MOH with indefinite timeout.
+PQC=X V.92 Phase 1 and Phase 2 Control.
X
Mode
0 Enable Short Phase 1 and Short Phase 2.
1 Enable Short Phase 1.
2 Enable Short Phase 2.
3 Disable Short Phase 1 and Short Phase 2.
+PSS=X Selection of full or short startup procedures.
X
Mode
0 The DCEs decide to use short startup procedures.
1 Forces the use of short startup procedures on next and subsequent connections.
2 Forces the use of full startup procedures on next and subsequent connections.
+VCDT = n
Caller ID Type.
n
Mode
0 = After ring only (Bellcore)
1 = Always on (Bellcore)
2=UK
3=Japan
+VCID = n
Caller ID Enable.
n
0 = Off
1 = Formatted caller ID enabled.
2 = Raw data caller ID enabled.
+VCIDR?
Type II caller ID information—”+VCIDR:” will be followed by raw caller ID information including
checksum. “No Data” will be displayed if no Type II data is available.
Table 20. Basic AT Command Set (Continued)
Command Action