User's Manual

Blue-1000 USB Stick
Linux:
Most distributors ship appropriate drivers in the standard installation. Those are part of the
official Linux kernel:
moritz@manhattan:~$ tail -f /var/log/messages
Apr 18 12:54:01 manhattan kernel: [16793.996020] usb 7-2: new full speed USB device using uhci_hcd
and address 3
Apr 18 12:54:01 manhattan kernel: [16794.223129] cp210x 7-2:1.0: cp210x converter detected
Apr 18 12:54:01 manhattan kernel: [16794.337524] usb 7-2: reset full speed USB device using
uhci_hcd and address 3
Apr 18 12:54:01 manhattan kernel: [16794.487217] usb 7-2: cp210x converter now attached to ttyUSB0
moritz@manhattan:~$ lsmod | grep cp210x
cp210x 11238 0
usbserial 33357 1 cp210x
Please make sure that you have permissions set right to access the serial devices at
/dev/ttyUSB*.
Further options:
For special demands like OEM versions of the drivers please consult the website [1] of the chip
manufacturer.
Working with the Blue-1000
Once the serial port is available in your system, you can connect to it with a terminal program.
Use the settings 115200,8n1 with RTS/CTS hardware flow control enabled.
The Blue-1000 will show up with this start up message:
WRAP THOR AI (4.0.0 build 317)
Copyright (c) 2003-2010 Bluegiga Technologies Inc.
READY.
Now you can use the iWRAP commands to request the Bluetooth functions. SET will show you
a summery of the active configuration:
SET
SET BT BDADDR 00:07:80:99:8f:62
SET BT NAME Blue-1000
SET BT CLASS 001f00
SET BT AUTH * 1111
SET BT IDENT BT:47 f000 4.0.0 Bluegiga iWRAP
SET BT LAP 9e8b33
SET BT PAGEMODE 4 2000 1
SET BT PAIR 00:07:80:9a:d8:b4 43c61e86c99f449eddf0937791c879a2
SET BT POWER 16 20 16
SET BT ROLE 0 f 7d00
SET BT SNIFF 0 20 1 8
SET BT MTU 667
SET CONTROL BAUD 115200,8n1
SET CONTROL CD 00 0
SET CONTROL ECHO 7
SET CONTROL ESCAPE 43 00 1
SET CONTROL GAIN 0 5
SET CONTROL MSC DTE 00 00 00 00 00 00
SET CONTROL PREAMP 1 1
SET CONTROL READY 00
SET PROFILE SPP Bluetooth Serial Port
SET
2