User's Manual

Team2 SW help
combination. The Team
2
software will inform you with yellow triangles in the Transmitters tab (of
Software Preferences) and in the upper right corner of the Team
2
software, if synchronization is
required. To find out the reason for the yellow triangle, take the mouse cursor on the symbol and
a message is displayed.
If you had transmitters taught to the Team
2
system before the base station combination changed,
follow the steps below:
1. Connect the main base station with the PC
.
2. Go to software preferences (Tools > Preferences > Transmitters tab).
3. Insert transmitters into the charger in non-secured mode. For more information, see the
Non-secured transmitter mode
page.
4. Plug the power cable into the charger.
5. As soon as transmitters are synchronized with the new base station combination, the
triangles disappear from the Transmitters tab.
6. Repeat steps 3 to 5 until you have synchronized all the transmitters.
NOTE:
• Similar yellow triangles are displayed also when the transmitters are taught to the system
before the teaching is finalized. To find out the reason for the yellow triangle, take the
mouse cursor on the symbol and a tooltip message is displayed.
• If you teach the connectors to the system after you have introduced all the base stations,
synchronization is not required.
How to Use Transmitters
In order the transmitters to work properly (record and transmit heart rate data), these instructions
must be followed.
1. Wet the electrode areas of the strap well under running water.
2. Attach the connector to the strap. Adjust the strap length to fit tightly but comfortably.
3. Tie the strap around your chest, just below the chest muscles, and attach the hook to the
other end of the strap.
4. Check that the wet electrode areas are firmly against your skin and that the Polar logo of
the connector is in a central and upright position.
35