User's Manual

Team2 SW Help
Windows Vista:
1. Switch on the main base station. Wait until the light 1 on the base station is lit.
2. If there's a separate on/off switch for the Wi-Fi adapter (of your PC), make sure that the
adapter is switched on.
3. Open Network and Sharing Center by selecting Start > Control Panel > Network and
Sharing Center on your PC.
4. Click View status of the wireless network connection.
5. If the Media State is disabled, click the Enable button at the bottom of the window.
6. Select Start > Connect to.
7. Wait for couple of seconds while the computer searches the networks. If the main base
station's name (base station's wireless network) doesn't appear on the list, try to refresh
the list by clicking Refresh network list on the left panel.
8. Select the main base station's wireless network from the networks list and click Connect.
9. You are asked to give the network key to finalize the connection. Light 2 on the base
station is lit when Team
2
software is running and the connection is OK.
NOTE:
• If you are using different software, provided by the PC or Wi-Fi adapter manufacturer, to
manage wireless connections, these instructions do not apply. In that case, you can find
more information from the connection management software's help or web site.
• If you have problems with connecting to the base station:
• Some computers block the Wi-Fi connection automatically if the Ethernet cable is
plugged in even though the Wi-Fi adapter is enabled. If this is the case, remove
the Ethernet cable from the PC connector if it is plugged in.
• Some computers block the Wi-Fi connection automatically if you are using a
docking station. If this is the case, remove the laptop from the docking station if a
docking station is in use.
How to synchronize transmitters with new base stations
After you have introduced secondary base stations (one or two) or replaced the main base station
to the system, you will have to synchronize the transmitters with the new base station
34