User's Manual

Team2 SW help
1. Turn on your PC and open Team
2
software.
2. Plug the power cable into the new main base station (reset secondary base station or
brand new). NOTE that using power cable is only allowed indoors. During outdoor use,
use the battery as power source.
3. Connect the new main base station to the PC with the network cable.
4. Switch on the main base station. Wait until (1) and (2) are lit (approx. 1. min).
5. Make sure the main base station is introduced to the system: go to software preferences
(Tools > Preferences > Base station/USB dongle tab). The main base station should
be on the base station list. If you want to change base station settings (name or wireless
network key), do it before introducing the secondary base stations.
6. Introduce the possible secondary base stations according to the instructions (How to
introduce additional base stations).
7. After you have introduced base station(s) to the system, you will have to synchronize the
transmitters with the new base station combination. See instructions in How to
synchronize transmitters with new base stations.
How to reset base station
If the base station has been previously introduced to any Team
2
or Cardio GX system (as a main
or secondary base station), it must be reset before it can be introduced to the system (as a main
or secondary base station) again.
1. Switch on the base station, do not connect it with the PC. Make sure the other base
stations are switched off.
2. Wait until light (1) is lit on the base station.
3. Push the reset button on the base station front panel
with a pen or pencil. The reset
button can be found under the plug.
4. Repeat for all base stations.
5. Introduce the base station to the system as a main base station (information in How to
connect base station to PC) or as a secondary base station (How to introduce additional
base stations).
How to Setup Wireless Connection
31