User's Manual

Team2 SW Help
• Make sure you are using the correct wireless network key. The network key is set in the
Preferences of the software. If you have forgotten your wireless network key, change it
according to the instructions
.
• If there are visible light indicators in your Wi-Fi adapter, check that they are flashing. The
flashing means that the connection is working.
• If you have a separate on/off switch for your Wi-Fi adapter (e.g. touch button on your
laptop's keyboard), make sure the adapter is switched on.
• Make sure that your wireless connection adapter is enabled:
1. Select Start > Control Panel > Network connections.
2. Right-click Wireless Network Connection.
3. If the right click menu includes option the Enable option, the adapter is currently
Disabled. In this case, select Enable.
• Some computers block the Wi-Fi connection automatically if the Ethernet cable is
plugged in. If this is the case, remove the Ethernet cable from the PC connector.
• Some computers block the Wi-Fi connection automatically if you are using a docking
station. If this is the case, remove the laptop from the docking station.
If you have checked all the issues mentioned above:
1. Close the software and switch off the main base station.
2. Open the software and switch on the main base station again.
If the connections still do not work, make sure that your PC is trying to connect to the main base
station:
1. Select Start > Control Panel > Network connections.
2. Right-click Wireless Network Connection and select View Available Wireless
Networks.
3. Select the Polar network from the list and click Connect.
4. Computer prompts you for the wireless network key.
If you have checked all the issues mentioned above:
146