User's Manual

Team2 SW Help
• There was only a PDA device used during online training and there was no data recorded
onto the PC.
To transfer data from the transmitters' memory:
1. Open the Team
2
PC software.
2. Switch on the base station. Wait until the connection is ready between the base station
and the PC.
3. Insert the transmitters into the charger and plug in the power cable.
4. Select a team.
5. Select Tools > Transfer Training Sessions. The Select Transmitters to Transfer Files
window appears.
6. Select All files or New files at the bottom of the screen according to your wishes. When
New files is selected, the software shows transmitters in 3 groups: transmitters that have
new files (In charger: new files), transmitters that don't have new files (In charger: no
new files), and transmitters that are not in the charger (not in charger).
7. Check the transmitters you want to transfer data from. Check All transmitters if you
want to select all transmitters.
8. Select the Transfer to PC button to begin the transfer. Wait until the transfer is finished.
9. A list of found training files is shown. Select a player and a training activity for each
training session.
10. Select the training sessions you wish to save by checking the box.
11. Save the training session by selecting Save.
NOTE:
• The charger must be in close range (max. 2 meters (6.5 ft)) from the base station (or the
USB dongle) during the training session files are transferred from the transmitters'
memory.
• If New files is selected, you cannot select the transmitters that do not have new training
files. If you want to transfer data from all transmitters' memory, select All files.
• If you get Transferring Files Not Allowed: Transmitter X warning during file transfer,
the transmitter in question is in non-secured mode and the data transfer to the PC is not
118